Datasheet
8
www.ittcannon.com
Dimensions shown in mm
Specifications and dimensions subject to change
Cannon VG/CA-Bayonet
Me cha ni cal Features
Ambient temperature
Stan dard insulator material
–55°/125°C (– 67/257°F)
FKM insulator material*
–30°/200°C (–22/392°F)
Safety provisions**
In mated condition
General (All connectors):
IP67 acc. to . DIN 40050
VG 95234 Connectors:
1 bar for 16h
IP69k Version Connectors:
Plug with Universal Endbell and receptacle with O- RIng
IP68 (1bar for 16h); IP69k (Water jet sealed) acc. to DIN 40050
Vibration test
200 m/s
2
at 10 to 2000 Hz
Mating cycles
500 min.
Withdrawl force per contact.
The corresponding separating force has to be measured
accord ing to VG95319, part 2, test no. 5.7. using the required
test gage and DIN EN60512-16-5.
Contact size Separating force min.
me tric AWG N Gage
10 – 0,3 G 0,99
15S/15 16S/16 1,0 G 1,56
25 12 1,5 G 2,36
60/100 8 3,0 G 3,58
160 4 4,0 G 5,69
500 0 8,5 G 9,04
Gage
(see also VG95234, Part 1)
Coupling torque
The allowable coupling torques have to be tested under full
bun dle conditions of the connectors to VG95319, part 2, test no.
5.8.2.
Shell Allowable coupling torque
size closing and opening Opening
Nm max. Nm min.
10SL 1,7 0,15
12S 2,5 0,23
14S 3,6 0,35
16S/16 5,5 0,46
18 8 0,58
20 9 0,7
22 11 0,8
24 14 0,8
28 17 0,92
32 19 1,03
36 23 1,03
Contact retention
The contact retention has to be tested according to VG95319,
part 2, test no. 5.4. Test force direction = Mating direction.
Contact Test force
size AWG N
10 – 30
15S/15 16S/16 35
25 12 55
60/100 8 80
160 4 90
500 0 95
Materials
Shell Alu mi n um alloy
Stan dar d finish Olive drab chromate coating over
cadmium plating
Alternative finish Zinc cobalt (see page 12 –
Modifica tion)
Insulator Po ly chlo ro prene (Stan dard)
and grommets FKM (High tem pe ra ture)*
Contacts Copper alloy
Stan dar d finish Hard silver
Special finish A176 nickel and hard gold plating
** upon request
** Longitudinal sealing: The connector is not sealed against fluids entering
through the cable, as the sealing lips of the single wire sealing are pressing
against the jacket of the individual conductors.
Gage Contact diameter d L
+0,01 –1
G 0,99 0,99 7
G 1,56 1,56 9
G 2,36 2,36 12
G 3,58 3,58 13
G 5,69 5,69 13
G 9,04 9,04 13