Datasheet

47
www.ittcannon.com
Dimensions shown in mm
Specifications and dimensions subject to change
Cannon CA-Bayonet IP69K
General Information
Scope
This specification describes a similar CA-B connector with a sealing degree up to IP69K. This connector is interchangable with the
corresponding types as per MIL-C-5015 and VG95234, as they offer the same mounting dimensions and contact arrangements. These
connectors are without spring washer, friction ring and grommet.
Recommended Method of Mounting
Connector shell is fixed with 4 screws on the housing. In combination with unsiversal endbell and an o-ring between flange receptacle
and wall the connector will reach IP68 sealing (1bar, 16h) and IP69K sealing.
Ratings & Characteristics
Locking Device Bayonet Coupling
Wire Size From 1,5mm
2
to 2,5mm
2
Contact Type Crimp or Solder Contacts
Electric Characteristics In accordance with VG95234 bayonet coupling
Environmental Characteristics In accordance with VG95234 bayonet coupling
Deviance with plating A240: 500h salt spray test with mated pair
Deviance with plating A34: 48h salt spray test
Water tightness for mated IP68 (1bar, 16h) and connector IP69K in combination with universal endbell and o-ring
connector (flange receptacle to wall)
Normative references
DIN EN 61984 (Electrical Connector, safety requirements and tests)
IEC 60068 (Environmental tests)
IEC 60352 (Crimp connection and requirements)
IEC 60512 (Electrical Connector, measuring and test procedure)
IEC 60529 (Specification for degrees of protection provided by enclosures)
VG 95373 (Electromagnetic compatibility)