Installation Guide
Table Of Contents
- 500W ERT® Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the 500W ERT Module
- 3 Initializing and Connecting
- 4 Installing the Remote 500W ERT Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
■
The lithium battery may cause a fire or chemical burn if it is not disposed of properly.
■
Do not recharge, disassemble, heat above 212°Fahrenheit (100°C Celsius), crush,
expose to water, or incinerate the lithium battery. Fire, explosion, and severe burn hazard.
■
The battery used in this device may present a risk of fire or chemical burn if mistreated.
■
Keep the lithium battery away from children.
Modifications and Repairs
Warning! This unit cannot be modified and is not repairable. Attempts to modify or
repair this module will void the warranty.
Disconnecting Power
Warning! Qualified technicians: during service, disconnect power to prevent
ignition of flammable or combustible atmospheres.
Electromagnetic Compatibility
Warning! Use only approved accessories with this equipment. Unapproved
modifications or operation beyond or in conflict with these instructions for use may
void authorization by the authorities to operate the equipment.
Electrostatic Discharge
Warning! Internal circuit components can be sensitive to electrostatic discharge.
Before installation, discharge electrostatic buildup by touching a metal pipe or other
earth-grounded metal object prior to touching the meter body, register housing, or
Itron device.
Do Not Drop
Warning! While Itron modules are designed to withstand a drop, dropping the
module may damage the device and void the warranty.
500W ERT Module Remote Installation Guide 1 Important Safety and Compliance Information
30 June 2021 815-0005-00 REV 008 Itron, Inc. Page 8 of 45










