Installation Guide
Table Of Contents
- 500W ERT® Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the 500W ERT Module
- 3 Initializing and Connecting
- 4 Installing the Remote 500W ERT Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
GenX 14
Events and Alarms 15
Mobile Mode 15
Network Mode 15
3 Initializing and Connecting 17
Programming 17
Encoder-type Register Connections 18
Pulser-type Register Connections 20
Connecting Using an Extension Cable 20
Verifying Operation 20
4 Installing the Remote 500W ERT Module 22
Mounting Accessories 22
Installing the Module Cable Strain Relief 23
Securing the Cable Strain Relief 23
Installing the Backplate 25
Attaching the Backplate 25
Pipe Mount Installation 27
Mounting the Pipe Bracket on a Vertical Pipe 27
OpenWay Riva Leak Sensor (OLS) Installation 30
Connecting the SET Valve 30
Completing the SET Valve Wire Connections 31
Remote Mount Installation 31
Installing on a Flat Surface 31
Direct-mounting to the Meter Register 33
Direct-mounting on the ABB Scancoder, InVision, or Digital Direct-Mount 33
Direct-mounting to a Badger Direct-Mount Register 35
5 Completing Gel-cap Connections Using the Itron Splice Kit 40
Required Materials 40
6 Using the Itron Cable Armor 43
Installing the Itron Cable Armor 43
7 Troubleshooting 45
30 June 2021 815-0005-00 REV 008 Itron, Inc. Page 4 of 45
500W ERT Module Remote Installation Guide Table of Contents