Installation Guide
Table Of Contents
- 500W ERT® Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the 500W ERT Module
- 3 Initializing and Connecting
- 4 Installing the Remote 500W ERT Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
7.
Warning! Use Itron mounting screws (SCR-0010-005). Using the wrong
mounting screws could crack the plastic module housing.
8. If you have not already done so, connect the register to the water meter and fully tighten
the mounting screw (1) as directed by Badger Meter.
Note: Mount the register on the meter in one of four different positions with respect to
the direction of water flow (refer to the manufacturer's installation directions).
500W ERT Module Remote Installation Guide 4 Installing the Remote 500W ERT Module
30 June 2021 815-0005-00 REV 008 Itron, Inc. Page 38 of 45