Installation Guide
Table Of Contents
- 500W ERT® Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the 500W ERT Module
- 3 Initializing and Connecting
- 4 Installing the Remote 500W ERT Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
4. Slide the remote 500W ERT module lug slot onto the mounting screw, pushing the remote
500W ERT module upward until the screw head is all the way into the slot.
5. Screw the remote 500W ERT module to the wall using the remaining two mounting
screws.
6. Insert a tamper seal over each mounting screw and drive into place with a nut driver or a
similar tool.
500W ERT Module Remote Installation Guide 4 Installing the Remote 500W ERT Module
30 June 2021 815-0005-00 REV 008 Itron, Inc. Page 32 of 45