Installation Guide
Table Of Contents
- 500W ERT® Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the 500W ERT Module
- 3 Initializing and Connecting
- 4 Installing the Remote 500W ERT Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
If the pipe is at a 45-degrees angle up to the left, install the adapter plate as shown.
If the pipe is horizontal, install the adapter plate as shown.
Mounting on the Adapter Plate
1. Locate the two 1-inch remote 500W ERT module mounting screws in the pipe mount kit.
2. Slide the remote 500W ERT module back cover onto the adapter, pushing up to secure
the lug adapter in the lug slot.
500W ERT Module Remote Installation Guide 4 Installing the Remote 500W ERT Module
30 June 2021 815-0005-00 REV 008 Itron, Inc. Page 29 of 45