Installation Guide
Table Of Contents
- 500W ERT® Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the 500W ERT Module
- 3 Initializing and Connecting
- 4 Installing the Remote 500W ERT Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
3. Align the remote module backplate with the mounting screw holes. Verify that the Itron
logo is not upside down.
4. Insert a backplate mounting screw in one corner and tighten the screw two or three turns.
Insert the remaining three screws and tighten each a few turns.
500W ERT Module Remote Installation Guide 4 Installing the Remote 500W ERT Module
30 June 2021 815-0005-00 REV 008 Itron, Inc. Page 26 of 45