Installation Guide
Table Of Contents
- 500W ERT® Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the 500W ERT Module
- 3 Initializing and Connecting
- 4 Installing the Remote 500W ERT Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
Installing the Backplate
After the connections are made to the register and optional telemetry device, attach the
remote 500W ERT module's backplate.
Mount the remote module after the backplate is attached.
Attaching the Backplate
1. Route the register cable and telemetry device cable through the dual-port backplate.
Ensure that the cable strain reliefs are inside the module housing and backplate assembly.
2. Route the register cable through the bottom backplate cable cutout and telemetry device
cable through the top backplate cable cutout.
500W ERT Module Remote Installation Guide 4 Installing the Remote 500W ERT Module
30 June 2021 815-0005-00 REV 008 Itron, Inc. Page 25 of 45