Installation Guide
Table Of Contents
- 500W ERT® Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the 500W ERT Module
- 3 Initializing and Connecting
- 4 Installing the Remote 500W ERT Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
2. Insert the pointed end of the cable tie into the receptacle end of the cable tie with the
ribbed edge facing in.
3. Pull the pointed end of the cable tie until the cable tie is hand-tightened.
4. Insert the excess cable tie into the cable tie gun. Pull the cable gun trigger to tighten and
clip the excess cable tie. The cable tie gun shown in the illustration is equipped with a red
dial that allows the user to set the cable tightening pressure of the cable gun.
Note: If your cable tie gun is equipped with a dial to set the tightening pressure, set the
pressure to ensure that the cable tie is secure on the lead wire. After installation, the
cable tie must not move on the register or secondary lead wire.
5. If your cable tie gun does not have a clipping feature, remove the cable tie from the cable
tie gun. Using a side cutter pliers, clip the excess cable tie.
6. Place the cable connection into the remote 500W ERT module housing with the cable ties
to the inside.
500W ERT Module Remote Installation Guide 4 Installing the Remote 500W ERT Module
30 June 2021 815-0005-00 REV 008 Itron, Inc. Page 24 of 45