Installation Guide
Table Of Contents
- 500W ERT® Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the 500W ERT Module
- 3 Initializing and Connecting
- 4 Installing the Remote 500W ERT Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
Caution: The FC300SR or Itron Mobile Radio are the only devices that support
programming for the remote module endpoint.
The remote module and programmer should be a minimum of 12-inches apart while
programming.
Do not place the programmer antenna directly on the remote module.
Encoder-type Register Connections
Connect the wires from the 500W ERT remote module to the register screw terminals
according to the following table.
Note: Itron recommends 19-26 gauge, pre-bonded or solid conductor wire with a
maximum diameter of .082" (individual wire insulation). The use of un-bonded wire may
produce an unreliable connection when using gel caps for joining wires.
Remote 500W ERT module wire color
Brown (data) Gray
(power/clock)
Yellow (ground)
Register manufacturer Register screw color designator
■ Badger
■ ADE
■ E Series
■ HR E LCD
■ HR E Mechanical
Green Red Black
Badger M5000 Mag Meter Green terminal: Out
4+
Red terminal: Input + Black Input - and Out
4 -
■ Elster AMCO
■ Invision
■ Scancoder
■ AquaMaster
■ AquaMaster III
Red Green Black
Diehl Hydrus Green White Brown
■ Elster AMCO
■ SM 700 (Severn Trent)
■ Q200 (Sensus protocol)
■ evoQ4 (Sensus Protocol)
Green Red Black
500W ERT Module Remote Installation Guide 3 Initializing and Connecting
30 June 2021 815-0005-00 REV 008 Itron, Inc. Page 18 of 45