User's Manual

TDC
-1666-000 OpenWay Riva Water Pit Module Installation Guide 21
Proprietary and Confidential
Using the Itron Cable Armor
This section describes the procedure for installing Itron cable armor in a field installation. The Itron cable
armor provides a layer or protection for the module's cable jacket. Itron cable armor is available in five-foot
sections.
Warning Itron cable armor is stainless steel and may have sharp edges. Use caution when you
are installing the cable armor.
Important If you remove the inline connector from the pit module to install the cable armor, you
must use an Itron handheld to reprogram the pit module using FDM Endpoint Tools. Perform a
Check Endpoint function (with FDM Endpoint Tools) after you reprogram the pit module to
verify communication with the meter register.
Required Materials
The following materials are required to install the Itron cable armor.
• 5-foot Itron cable armor
• Electrical tape
• (Optional) Scissors
To install the Itron cable armor
1. Remove the pit module from the pit.
Note If it is possible in your field installation, keep the pit module connected to the register.
2. Cut a two to three inch strip of electrical tape.
A PPENDIX A