User's Manual

Installing the OpenWay Riva Water Pit Module
TDC
-1666-000 OpenWay Riva Water Pit Module Installation Guide 19
Proprietary and Confidential
2. Insert the pointed end of the security seal into the capped end and push until the seal locks.
This completes the pit module and Riva Leak Sensor connections.
Optional Remote Water Disconnect Valve Installation
This section describes installation of a remote water disconnect valve in an OpenWay Riva water system.
The pit module automatically detects the presence of connected water disconnect devices. The pit module
automatically detects the device within 22.5 minutes and begins reading disconnect valve data. To
immediately detect the water disconnect valve and begin reading data, perform a Check ERT with a handheld
computer running FDM software.
The disconnect valve is used in conjunction with both indoor (basement) and outdoor (mounting on the
exterior of the house) pit module installations. Water disconnect devices are mounted on a water service pipe
or meter insetter (meter horn) and connect to the center telemetry connector (blue) on the pit module as
described in Installing the Remote Water Disconnect Valve on page 19.
Note Remote water disconnect operation requires an pit module with enhanced
security enabled.
Installing the Remote Water Disconnect Valve
The remote water disconnect valve ships from the supplier with the Itron cable installed. See the
manufacturer's installation instructions for the procedure to mount the disconnect valve in the pipe close to the
pit module.
To connect the remote water disconnect valve to the pit module
Caution Remote disconnect valves must mount to Port B (middle telemetry blue port) of the module.
Connecting the disconnect valve to the incorrect port will cause electrical damage to the disconnect valve
and pit module.