User's Manual

Installing the OpenWay Riva Water Pit Module
TDC
-1666-000 OpenWay Riva Water Pit Module Installation Guide 17
Proprietary and Confidential
3. Mount the sensor mounting clamp on the pipe on the water input side of the meter.
Caution Mount the Riva Leak Sensor on the water input side of the meter. Failure to follow this
mounting requirement could result in errors in the leak detection data. Installation requires Itron mounting
hardware. Repair costs and service charges relating to the use on non-compliant mounting hardware will
be charged to the customer. Contact Itron Support for more information.
Do not mount the leak sensor on a pipe coupler, joint, or nut.
4. Turn the Riva Leak Sensor's mounting base onto the mounting bracket post.
5. Align the Riva Leak Sensor mounting lock pin with the pin receptacle on the Riva Leak Sensor mounting
base and insert the sensor.
6. Turn the Riva Leak Sensor to lock the sensor into place.
Note For Riva Leak Sensor installations on pipes up to 2-1/2 inches, use the optional larger mounting
bracket. For more information, see the Water Products Ordering Guide PUB-0063-001.
Connecting the Riva Leak Sensor to the Riva Water Module
After the pit module is installed in the desired location, connect the pit module to the Riva Leak Sensor.
To connect the Riva Leak Sensor to the pit module
Caution The Riva Leak Sensor must mount to the blue telemetry connector of the pit module.
Connecting the sensor to the incorrect port will cause electrical damage to the Riva Leak Sensor and pit
module.
1. Remove the environmental cap from the blue telemetry connector of the pit module.
2. Remove the environmental cap from the leak sensor connector. Verify the connectors (the pit module
telemetry connector and the leak sensor connector) are clean and dry.