User's Manual

Installing the OpenWay Riva Water Pit Module
TDC
-1666-000 OpenWay Riva Water Pit Module Installation Guide 15
Proprietary and Confidential
3. Mark the location of the top mounting hole.
4. Drill a pilot hole in the pit box wall. Follow the screw manufacturer's recommendation for the pilot hole
size.
5. For concrete-type pit boxes, it may be necessary to use a screw anchor. Choose an anchor appropriate for
a #10 pan head screw.
Caution Do not over-tighten the mounting screws. Over-tightening the mounting screws may break the
pit module mounting tabs.
6. Start a screw into the pilot hole. Using the top hole of the pit module, set the pit module over the screw
head and slide it down so the screw is now at the top of the notch. Carefully tighten the screw until snug.
Over-tightening the mounting screw could damage the pit module housing.
Note If the mounting location requires a screw anchor, mark the location of the bottom anchor and
remove the pit module. Drill the required mounting hole, insert the anchor, and re-attach the pit module.
7. Holding the pit module in the upright position, drill the second pilot hole. Use the bottom mounting hole
as a template.
Caution Any pit module position other than upright may negatively affect radio performance and battery
life.
8. Screw the bottom screw into the pilot hole until snug. Do not over-tighten the mounting screw.