User's Manual

Installing the OpenWay Riva Water Pit Module
TDC
-1666-000 OpenWay Riva Water Pit Module Installation Guide 11
Proprietary and Confidential
This section provides the instructions to install the pit module in a pit lid with a hole using the Pit Lid
Mounting Kit (CFG-1300-004). Verify you have the following items to complete the installation.
A Retainer clip
B Pit lid with a pre-drilled hole
C Retainer clip collar
D OpenWay Riva Water Pit
Module
To install the module in lids with holes using the Pit Lid Mounting Kit
1. Insert the retainer clip into the pit lid hole with the convex surface on the top of the pit lid.
2. From the bottom side of the lid, screw on the threaded retainer clip collar until the beveled top rests
against the pit lid.
Note Ensure the beveled edge of the clip collar is toward the top of the pit lid.
3. Align and insert the retainer clip tab into the retainer clip receptacle on the pit module housing.
4. Verify the clip locks into place in the housing.
Caution Carefully align the pit module through lid assembly. If the assembly is improperly aligned, the
pit lid may not close.
Pit lid mounting installation is complete.