Installation Guide
Table Of Contents
- OpenWay Riva Gas Disconnect Installation Guide
- Table of Contents
- 1 Important Safety and Compliance Information
- USA, FCC Part 15 Spectrum Compliance
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Electromagnetic Compatibility
- Intrinsic Safety
- Lithium Battery
- Transportation Classification
- Modifications, Repairs, Installation, and Removal
- Aluminum Enclosure
- Electrostatic Discharge
- Electrostatic Ignition Hazard
- Device Cleaning
- Do Not Drop
- Product Notification
- 2 OWRGD Installation Guide Overview
- 3 About the OpenWay Riva Gas Disconnect
- 4 Installing the OWRGD
- 5 Connecting the Flood Sensor to the OWRGD
- 6 OWRGD Operations
5
Connecting the Flood Sensor to the OWRGD
The flood sensor connects to the OWRGD through an inline connector.
Warning! The OWRGD must be commissioned before the flood sensor is connected
to ensure proper event logging. After the flood sensor is attached to the OWRGD,
perform a Check Endpoint in FDM tools to verify the flood sensor is connected.
Connecting the Flood Sensor Inline Connector
1. Remove the protective cover from end of the flood sensor's inline connector by twisting the
protective cover tab to the left.
2. Discard or recycle the protective cover.
3. Align the inline connector pins with the OWRGD connector pins and push the connector
securely onto the gas disconnect device.
14 August 2020 815-0382-00 25