Installation Guide

Caution: Do not install the OpenWay Riva Gas Remote Disconnect with the gas out
flow in the down position or in such a way that the antenna is against a wall or other
structure.
Remove the red shipping plugs from the inlet and outlet to vent the OpenWay Riva
Gas Remote Disconnect prior to installation. Keep the piping interior
, regulator inlet,
and regulator outlet free from dirt, chemical sealant (pipe dope), Teflon tape, or other
debris. Materials in piping or regulator inlet or outlet create a loss of pressure
control. Apply pipe sealant on the male (exterior) pipe threads. Sealing materials can
lodge in the regulator and cause a loss of pressure control. Gas must flow through
the valve body in the same direction as the arrow on the valve. Gas flowing in the
wrong direction may prevent a disconnect.
OpenWay Riva Gas Remote Disconnect valve positions
The OpenWay Riva Gas Remote Disconnect valve positions are shown in the illustrations.
Valve open: valve slot horizontal Valve closed: valve slot positioned at angle
Note: For devices that are mounted in a horizontal position, the OpenW
ay Riva Gas
Remote Disconnect valve shaft is closed, the valve shaft is in a 7:00/1:00 orientation. The
valve rotates counterclockwise from open to closed but does not rotate a full 90 degrees. If
the device is mounted vertically, the valve shaft orientation changes to a 5:00/11:00
orientation.
Installing the OpenWay Riva Gas Remote Disconnect
OpenWay Riva Gas Remote Disconnect Installation Guide TDC-1759-000 14
Proprietary and Confidential