User Manual

OpenWay 3.5S User Information Manual
Industry Canada
This device complies with Part 15 of the FCC Rules [and with RSS-210 of Industry Canada].
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
En vertu de la réglementation d'Industrie Canada, cet émetteur radio peut fonctionner uniquement à l'aide
de l'antenne d'un type et maximale (ou moins) obtenir une approbation pour l'émetteur par Industrie
Canada. Pour réduire les interférences radio potentielles à d'autres utilisateurs, le type d'antenne et son
gain doivent être choisie que la puissance isotrope rayonnée équivalente (p.i.r.e.) n'est pas plus que celui
nécessaire à une communication efficace.
RF Exposure
The antennas used for this transmitter must be installed to provide a minimum separation
distance of 20 cm from all persons, and must not be co-located or operate in conjunction with any
other antenna or transmitter. End users and installers must be provided with antenna installation
procedures and transmitter operating conditions for satisfying RF exposure compliance.
Miscellaneous
The user’s manual for any product that contains this module will contain the following text:
Professional Installation
This module is intended for professional installation by the integrator. The OEM integrator is still
responsible for the FCC compliance requirement of the end product which uses this module.
Modification and Repairs
To ensure FCC compliance and system performance, this device, antenna and/or coaxial assembly shall
not be changed or modified without the express written approval of Itron. Any unauthorized modification