Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Caution: For Australia the required minimum loss between the CGR/CAM3 and
8.15dBi antenna is 2.2dB in addition to the required RF Filter and the supplied cable
between the CGR and the RF Filter.
Additionally, Itron recommends, you select a backhaul cellular provider that does not operate in
the passband of the CAM3S/CAM3M, as this results in desensing the CAM's receiver as the two
antennas are so close together.
02 March 2020 815-0080-00 Itron, Inc. Page 95 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide B RF Filter Installation