Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 93RF Filer to CGR Connection
2. Connect the other end of the RF Cable, see item 1, to the N Connector on the bottom of the
RF Filter.
Figure 94RF Filer to CGR Connection
Australia Applications
To meet regulator requirements in Australia for the CAM3S or CAM3M in either a Star or Mesh
deployment, ensure you comply with either of the following configurations:
1. Use the 915MHz 2.8dBi WPAN antenna on the CGR for CAM3M.
2. Use the 915MHz 5.5dBi or 915MHz 8.15dBi remote antenna with the RF Filter for CAM3S.
02 March 2020 815-0080-00 Itron, Inc. Page 94 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide B RF Filter Installation