Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 89Six Captive Bolt Sequence to Tighten the CGR's Door
19. Remove the old CAM compliance label from the CGR. If peeling off the label is unsuccessful,
use a permanent marker to mark through the FCC and IC IDs, as they are no longer valid.
20. Clean the surface and affix the regulatory label (included in the CAM3S/CAM3M installation
kit) to the front bottom right of the exterior of the CGR's door shown in the figure inside the
red circle.
Figure 90Update the FCC Regulatory Label
The following line should be included on the label:
Contains: FCC ID EO9OW3
02 March 2020 815-0080-00 Itron, Inc. Page 84 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field