Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
11. Type enable at the prompt.
12. Type the console password and press Enter.
13. At the config prompt, enter endto return to the original command prompt, see item 1.
14. Enter copy r s at the prompt, see item 2.
15. When prompted for Destination filename, enter start-up-config" and pres Enter, see item 3.
16. Type exit at the prompt.
17. Call your local Field Network Director (FND)/ Cisco Grid Network Management System
(CGNMS) FND/CGNMA operator to confirm CAM3S/CAM3M operation. When operation is
confirmed, you can unplug the console cable.
Figure 88PuTTY Screen - CAM3M End
18. Close the door and secure by tightening the six captive bolts using the sequence shown in
figure. Use a torque of 6 to 7ft-lb when tightening the bolts.
02 March 2020 815-0080-00 Itron, Inc. Page 83 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field