Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 86PuTTY Screen - CAM3M Power Up
Important! The CAM3S/CAM3M only fits into Slot 5 of the CGR. In this example, the
existing CAM is located in Slot 4. If your existing CAM is located in Slot 5, the same
procedure applies.
8. At the config prompt, enter hw-module power off 4 (Slot 4), see item 1.
Note: If the CAM is located in Slot 5, enter hw-module poweroff 5.
9. At the config prompt, enter do show module, see item 2.
10. Verify that the new Status indicates ok, see item 3.
Figure 87PuTTY Screen -CAM Status
After PuTTY connects to the CGR, a console terminal appears. If you do not see a terminal
prompt, press Enter until the terminal prompt appears. If you still do not get a prompt, exit PuTTY
and switch to another baud rate other than 9600.
Note: Make sure that the cable is attached and undamaged.
02 March 2020 815-0080-00 Itron, Inc. Page 82 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field