Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Important! For new installations, or for a Star deployment running IOS v15.6.3m1,
on your CGR you must upgrade to IOS v15.8.3m1. However, for existing Mesh
deployments, no IOS upgrade is required.
For detailed information about how to upgrade your IOS version, See CGR IOS Upgrade Guide,
(815-0001-xx).
Guide Conventions
The following visual elements are used throughout this guide, when applicable.
Warning! This icon and text indicates hazardous situation, which if not avoided, could
result in death or injury.
Caution: This icon and text indicates a potentially dangerous procedure. Instructions
contained in the warning must be followed. Failure to do so may result in damage to
the device.
Important! This icon and text indicates important things the user should pay attention
to.
Note: This icon and text designates information of a special note.
Tip: This icon and text indicates information to make things easier to use.
Related Product Documentation
Document Name Software
Version
Part Number Link
CGR IOS Upgrade Guide v15.5 or later 815-0001-xx N/A
Cisco 1240 Connected Grid
Router Hardware Installation
Guide
N/A N/A Cisco 1240 Connected Grid Router
Hardware Installation Guide
Table 2Product Related Documentation
02 March 2020 815-0080-00 Itron, Inc. Page 8 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 1 About This Guide