Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
17. Remove the RF coaxial cable from the existing CAM's RF QMA Connector, see item 1.
18. If applicable, remove the PLC Signal Cable from the 6-Pin Connector, see item b.
19. Remove the two Phillips screws securing the CAM into the CGR, see item 2.
20. Grasp both of the handles, see item 3. And pull up and out to slide the CAM out of the CGR.
Figure 83CAM Handles, Phillips Screws and RF QMA Connector Location
02 March 2020 815-0080-00 Itron, Inc. Page 79 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field