Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 77RJ45 Connector Location
5. Open the Windows Device Manager and locate the Prolific USB-to-Serial Comm Port and
assign.
Figure 78Windows Device Manager USB to Serial Com Port Selected
6. Open a new PuTTY session, see figure, and perform the following steps:
a. Enter the Com Port value in the Serial Line field, see item a, COM22 shown as an example.
b. Set the port Speed to 9600, see item b, in the Speed field. This is the baud rate.
c. Select Serial, see item c, in the Connection Type field.
d. Click the Open button, see item d.
02 March 2020 815-0080-00 Itron, Inc. Page 75 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field