Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 75Hex Bolt Plug - RJ45 Connector Location
3. Locate the Cisco DB9-RJ45 Serial Cable , and the USB-to-Serial Adapter Cable. Both are
shown connected in figure. The left-most blue cable is the DB9-RJ45 Serial Cable and the
right-most cable is the USB-to-Serial Adapter Cable.
Figure 76Cisco DB9-RJ45 Serial Cable and USB-to-Serial Adapter Cable
4. Plug the blue Cisco DB9-RJ45 Serial Cable, RJ45 end, into the CGR's RJ45 Connector,
see figure, that you accessed located on the right hand side top of the CGR.
02 March 2020 815-0080-00 Itron, Inc. Page 74 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field