Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
The CGR's chassis hardware features Door Sensor located inside the door, see the highlighted
red item. The Door Sensor is a pressure-sensitive alarm switch that detects the opening and
closing of the CGR's door and alerts the Field Network Director (FND)/ Cisco Grid Network
Management System (CGNMS) FND/CGNMS operator to a potential security breach. When
the switch detects the door has been opened or closed, it sends an event message to the CGR,
which is stored in the router log file.
Figure 74CGR's Door Sensor Location
2. Remove the 1/2" (13mm) Hex bolt plug, see item 1, located on the right hand side top of the
CGR to gain access to the RJ45 connector.
02 March 2020 815-0080-00 Itron, Inc. Page 73 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field