Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 65AC Power Connection Location
2. Wire the 5 pin cable to the low voltage side of the transformer using the tables indicating the
applicable wiring diagrams.
Cable Color Function Wire#
Black Neutral 1
Black Line 1 2
Black No connection and should be insulated. 3
Black No connection and should be insulated. 4
Green/Yellow Ground 5
Table 66Single Phase Wiring (110/240VAC)
Warning! Ensure you follow the wiring diagrams. The no connected wires should be
insulated to avoid connections with individuals or other items. Uninsulated wires are a
hazardous situation, which if not avoided, could result in death or injury.
02 March 2020 815-0080-00 Itron, Inc. Page 66 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 6 ACT Coupler Unit Installation (CAM3M Only)