Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 54RF QMA Connector and WPAN Antenna Connection Location
11. Ensure that the cables are routed so that they do not interfere with door closure. Use a single
plastic cable tie, see item 3, to secure both the PLC Signal Cable, see item 1 and the
antenna cable, see item 2, to the tie loop on the front of the CAM3S/CAM3M.
Figure 55Signal Cable, RF Antenna Cable and Plastic Cable Tie Location
12. Close the CGR's door and tighten the six captive bolts the secure the hinged door using the
sequence shown in the figure. Use a 1/2" (13mm) socket wrench and apply a torque of 6 to
7ft-lb.
02 March 2020 815-0080-00 Itron, Inc. Page 58 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 5 Radio Frequency and Power Line Carrier Installation