Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 536-Pin Connector Location
10. Secure the black antenna wire from the appropriate antenna to the RF QMA Connector, see
item 1, on the front of the CAM3S/CAM3M.
Note: The CGR ships with two antenna connection options: the Wireless Personal Area
Network (WPAN) antenna, see item 2, and a remote mounted antenna. Internal antenna
cables are provided for both options. You must select the internal antenna cable that
connects to antenna (either the WPAN for the CAM3M, or remote mounted for the CAM3M)
being used for this installation and connect it to the RF QMA Connector, see item 1, on the
front of the CAM3S/CAM3M.
Caution: The CAM3S is for Star deployments and uses the remote antenna . In
contrast, the CAM3M is for Mesh deployments and uses the WPAN antenna instead.
This is the only difference when is comes to deployment between the two devices.
02 March 2020 815-0080-00 Itron, Inc. Page 57 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 5 Radio Frequency and Power Line Carrier Installation