Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 51PLC Signal Cable Insertion Location
7. Route he PLC Signal Cable through the hole, see item.
8. Secure the Cable Gland into the threaded hole, as shown. Use a 15/16" combination wrench
to secure the cable gland.
Figure 52PLC Signal Cable and Cable Gland Location
9. Insert the PLC Signal Cable into the 6-Pin connector, see item 1, on the front of the
CAM3S/CAM3M.
02 March 2020 815-0080-00 Itron, Inc. Page 56 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 5 Radio Frequency and Power Line Carrier Installation