Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 49Slot 5 Label, CAMS3/CAM3M and Retaining Screws Location
5. Remove the PLC Signal Cable Hex bolt plug, see item 1, using a 1/2" (13mm) socket
wrench.
Figure 50Hex Bolt Plug Location for PLC Signal Cable
6. Insert the PLC signal cable, see item 1, into the bottom of the CGR.
02 March 2020 815-0080-00 Itron, Inc. Page 55 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 5 Radio Frequency and Power Line Carrier Installation