Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
closing of the CGR's door and alerts the Field Network Director (FND)/ Cisco Grid Network
Management System (CGNMS) operator to a potential security breach. When the switch
detects the door has been opened or closed, it sends an event message to the CGR, which is
stored in the router log file.
Figure 41CGR’s Door Sensor Location
5. Reconnect the Battery Backup Unit (BBU) Harness Cable, see item 1, from the Battery
Backup Unit located on the inside of the CGR's door.
02 March 2020 815-0080-00 Itron, Inc. Page 47 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 4 Star and Mesh Deployment Installation