Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
3. Ensure that the tape fully covers the cable strain relief.
4. Wrap a layer of Butyl rubber sealant over the vinyl electrical tape
Figure 36Butyl Rubber Application
5. Ensure that the Butyl rubber extends past the vinyl electrical tape and onto the cable jacket.
6. Overlap the Butyl rubber so that no gap exists. The Butyl rubber self-vulcanizes over time
and the seam disappears.
7. Wrap vinyl electrical tape around the Butyl rubber, starting at the filter and moving up as you
did in step 1.
Figure 37Electrical Tape Application Around the Butyl Rubber
02 March 2020 815-0080-00 Itron, Inc. Page 44 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 4 Star and Mesh Deployment Installation