Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
1. Push the 1¾" bolt through the antenna holder, the remote mount adapter plate, and the
mounting bracket
2. Place the flat washer on the bolt.
3. Place the split washer on the bolt.
4. Add a drop of anti-seize lubricant to the nut and attach the nut to the bolt.
5. Replace the black rubber bumper on the end of the antenna
Figure 33Remote Antenna to CGR Mounting Bracket
Weatherproofing the RF Connections
1. Wrap vinyl electrical tape around the connection, starting at the RF Filter and moving up the
cable as shown in the figure.
02 March 2020 815-0080-00 Itron, Inc. Page 42 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 4 Star and Mesh Deployment Installation