Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 26Remote Antenna, Lighting Arrestor Connections with a RF Filter
Assembling and Attaching the Antenna
This section describes the procedures needed to assemble the remote antenna and attach it to
the CGR. You will also need to install a grounded lightning arrestor to prevent lightning damage
to the CGR. See Remote Antenna Connections & the Lightning Arrestor.
Assembling the Remote Antenna
1. Remove the black rubber bumper from the end of the antenna.
02 March 2020 815-0080-00 Itron, Inc. Page 38 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 4 Star and Mesh Deployment Installation