Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Connector on the CGR (or RF Filter). The surge end of the arrestor is connected to the antenna
cable. The arrestor is also furnished with a ground lug
Caution: .The lightning arrestor must be connected to an earth-ground.
This figure shows the Remote Antenna connected to a CGR without a RF Filter. Specifically,
shows the Remote Antenna, item 1, a RF Cable, item 2, the Lightning Arrestor, item 3, and the
CGR's N Connector, see item 4.
Figure 25Remote Antenna, Lighting Arrestor Connections without a RF Filter
This figure shows the Remote Antenna and a RF Filter connected to a CGR. Specifically, shows
the RF Cable, item 1, that connects between the RF Filter and the Antenna, the Lightning
Arrestor, item 2, the RF Filter, item 3 and the RF Cable, item 4, that connects between the
CGR's N Connector and the RF Filter.
02 March 2020 815-0080-00 Itron, Inc. Page 37 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 4 Star and Mesh Deployment Installation