Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 22Mounting Bracket and Hex Bolt Installation
4. Insert the remaining three hex bolts, see item 2, on each side of the CGR into their
respective places.
Note: Insert all hex bolts on each side before securing tightly.
5. Tighten all hex bolts. Use a torque of 6 to 7ft-lb when tightening the bolts.
Figure 23Hex Bolts Location on Side of CGR
6. Close the door and secure by tightening the six captive bolts using the sequence shown in
figure. Use a torque of 6 to 7ft-lb when tightening the bolts.
02 March 2020 815-0080-00 Itron, Inc. Page 34 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 4 Star and Mesh Deployment Installation