Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Note: Ensure you route the antenna cables so it not impede the door closure. Use a single
plastic cable tie to secure the antenna cable to the metal tie loop on the front of the
CAM3S/CAM3M.
Figure 18WPAN, Remote Antenna Connection and RF QMA Connector Location
6. Close the CGRs door and tighten the six captive bolts that secure the hinged door using the
sequence shown in the figure. Use a 1/2" (13mm) socket wrench and apply a torque of 6 to
7ft-lb.
02 March 2020 815-0080-00 Itron, Inc. Page 31 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 4 Star and Mesh Deployment Installation