Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 17CGR's Slot 5 and CAM3M's Retaining Screws Location
3. Insert the CAM3S/CAM3M, see item 2, into Slot 5 of the CGR. Ensure that the
CAM3S/CAM3M PCBs edge connector is on the right side and aligns with the PCI-E 98-pin
connector on the CGR mother board. Gently press the CAM3S/CAM3M until the card-edge
connector is firmly seated into the connector.
4. Tighten the retaining screws, see item 3, on the front of the CAM3S/CAM3M, securing the
CAM3S/CAM3M in place. Use either a #2 Phillips or a 9/32" flat-blade screwdriver and apply
a torque of approximately 10in-lb.
5. Secure the black antenna wire from the appropriate antenna to the RF QMA Connector, see
item 1, on the front of the CAM3S/CAM3M.
Note: The CGR ships with two antenna connection options: the Wireless Personal Area
Network (WPAN) antenna connection, see item 2, and a remote mounted antenna
connection, see item 3. Internal antenna cables are provided for both options. You must
select the internal antenna cable that connects to the antenna (either the WPAN or remote
mounted) you are using for this installation and connect it to the RF QMA Connector, see
item 1, on the front of the CAM3S/CAM3M.
For more information about the remote antenna. See Installing the Remote Antenna
02 March 2020 815-0080-00 Itron, Inc. Page 30 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 4 Star and Mesh Deployment Installation