Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Figure 16Mounting Bracket Rear Hex Bolt Locations
Installing the CAM3S/CAM3M
Warning! Do not install a CAM3S/CAM3M in a CGR that contains a Cisco CGR
Compute Module. To allow for sufficient heat dissipation, make sure that a slot
adjacent to the CAM3S/CAM3M is empty.
Important! The CAM3S/CAM3M only fits into Slot 5. This is required for sufficient
heat dissipation. Additionally, this is the only slot that allows the use of up to three
Battery Backup Units (BBUs).
1. Locate Slot 5 by the slot identifier label, see item 1, inside the CGR.
2. Loosen the two Phillips screws on the blank cover over Slot 5 and remove the cover. Use
either a #2 Phillips or a 9/32" flat-blade screwdriver.
02 March 2020 815-0080-00 Itron, Inc. Page 29 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 4 Star and Mesh Deployment Installation