Installation Guide
Table Of Contents
- OpenWay® Riva CAM3S and CAM3M Installation Guide
- Table of Contents
- New in this Document
- 1 About This Guide
- 2 Introduction
- 3 Installation Kits
- 4 Star and Mesh Deployment Installation
- 5 Radio Frequency and Power Line Carrier Installation
- 6 ACT Coupler Unit Installation (CAM3M Only)
- 7 Replacing an Existing CAM with a New CAM3S/CAM3M in the Field
- A Specifications
- B RF Filter Installation
- Glossary
- Index
Flat washers (6)
Split washers (6)
Nuts (6)
Pipe clamp hangers (2)
Silicone seal
Anti-seize lubricant
Caution: Do not install a 5.5dBi antenna directly on the CGR/CAM3. Antenna
installation directly on the CGR/CAM3 compromises mechanical integrity and will not
meet the compliance requirements.
915MHz 5.15dBi Remote Antenna Kit
The following items are included in the Remote Antenna installation kit (KIT-0049-001):
■
915 MHz 5.15dBi gain antenna
■
Antenna mounting kit:
Remote-mount adapter
Antenna holder
Mounting bracket
6-inch bolts (4)
1¾-inch bolts (2)
Flat washers (6)
Split washers (6)
Nuts (6)
Pipe clamp hangers (2)
Silicone seal
Anti-seize lubricant
Caution: Do not install a 5.5dBi antenna directly on the CGR/CAM3. Antenna
installation directly on the CGR/CAM3 compromises mechanical integrity and will not
meet the compliance requirements.
02 March 2020 815-0080-00 Itron, Inc. Page 20 of 102
OpenWay® Riva CAM3S and CAM3M Installation Guide 3 Installation Kits