User Manual

CAM Installation for RF/PLC Applications
OpenWay® Riva™ CAM / ACT Coupler Unit 12
Install CAM for RF/PLC Applications
Illustration Callout Number Description
1
Slot #5 identifier label
2
CAM (OW1)
3
CAM retaining screws
1. Locate Slot #5 by the slot identifier label in the CGR.
2. Insert the CAM in slot #5 of the CGR. Ensure the CAM is oriented so that the connectors on the rear of
the CAM are aligned with those in the slot #5. Gently press the CAM until the card-edge connector on the
CAM is firmly seated into the connector in the CGR.
3. Tighten the retaining screws on the front of the CAM securing the module in place. Use either a #2
Phillips or a 9/32" flat blade screwdriver.