User's Manual

SSI OPENWAY 1X SmartMeter User Guide
SMR45-4601B 16
6 Requirements and Compliance
The SSI OPENWAY 1X SmartMeter is compliant with all applicable Federal Communications
Commission (FCC) and Industry Canada requirements. The FCC and IC identification numbers for the
SSI OPENWAY 1X SmartMeter are listed as follows:
FCC identifier: QHC-OPENWAY1X
IC Identifier: 4393B-OPENWAY1X
This certification is granted to SmartSynch Inc.
6.1 FCC Grant Statement
The antennas used for this transmitter must be installed to provide a minimum separation
distance of 20 cm from all persons, and must not be co-located or operate in conjunction
with any other antenna or transmitter.
6.2 Compliance Statement (Part 15.19)
The SSI OPENWAY 1X SmartMeter complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
6.3 Warning (Part 15.21)
Changes or modifications not expressly approved by Itron and SmartSynch Inc. could void the user’s
authority to operate the equipment.
6.4 RF Radiation Safety Guidelines per Part 2 of FCC Rules and
Regulations
The meter should be installed in a location where there will be a separation greater than 20 cm (8 inches)
from locations occupied by humans.