User's Guide
Table Of Contents
- Chapter 1: Important Safety and Compliance Information
- Chapter 2: Overview
- Chapter 3: Module Description
- Chapter 4: Connecting, Initializing and Programming the Module
- Chapter 5: Approved Antennas for the Modular LE
USER GUIDE ITRON CONFIDENTIAL 16
4. Connect the serial to USB cable with the three pin connector on the far left of the image shown in
Figure 8. The yellow in the middle and the black (ground) in the position closest to the end of the
board. Plug the USB end of the cable you’re your laptop.
Figure 8: Module on host board and connected to Serial to USB cable
Once all the connections are in place, your board should be connected as shown in Figure 9 and you are
ready to load firmware on your module.
Figure 9: Module on fully connected host board