Setup Guide
Table Of Contents
- Intelis Gas Meter Proving and Setup Guide
- Contents
- New in this Document
- 1 Important Safety and Compliance Information
- USA, FCC Part 15 Spectrum Compliance
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Australia, ACMA Spectrum Compliance
- Electromagnetic Compatibility
- Intrinsic Safety
- Lithium Battery
- Transportation Classification
- Electrostatic Discharge
- Electrostatic Ignition Hazard
- Device Cleaning
- Do Not Drop
- Product Standards
- 2 Overview
- 3 Proving
- 4 Proving the Intelis Gas Meter Using the Honeywell SNAP Proving System
- 5 Proving the Intelis Gas Meter Using the Measurement Systems Proving System
- 6 Proving the Intelis Gas Meter Using the Energy Economics (EEI) Proving System
- 7 Calibrating the Intelis Gas Meter
6. Select Enter New Meter Model.
7. Select an existing meter model similar to the new meter as a template. Itron recommends
using the S-250 for an Intelis 250 gas meter and an S-250 TC for the Intelis 250 TC gas
meter. Select the green bar on the bottom of the screen to use the selected meter as the
starting point.
Note: Measurement Systems uses the lack of TC at the end of the meter name to
designate a non-TC meter, for example; an S-250 is an Itron I-250 CFH non-TC meter
and an Intelis 250 would designate an Intelis 250 CFH non-TC meter.
08 July 2020 815-0154-00 REV 000 Itron, Inc. Page 36 of 66
Intelis Gas Meter Proving and Setup Guide
5 Proving the Intelis Gas Meter Using the Measurement Systems
Proving System