User's Guide
Table Of Contents
- Table of Contents
- Itron Mobile Radio compliance
- 1. Introduction
- 2. About Your Itron Mobile Radio
- 3. Daily Operation
- 4. LED Status Indicators
- 5. Communication Ports
- 6. Carrying the Portable Itron Mobile Radio
- 7. Installing the IMR-XA and IMR-FT
- 8. Maintaining your Itron Mobile Radio
- 9. Storing Your Radio
- 10. Battery Basics
- 11. Safety
- 12. Troubleshooting
- 13. Optimizing Bluetooth® Performance
- 14. Itron Mobile Radio Capabilities and Limitations
Compliance Statement Canada Déclaration de Conformité
opment Canada (ISED) regulations, this radio trans-
mitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the trans-
mitter by Innovation, Science and Economic Devel-
opment Canada. To reduce potential radio
interference to other users, the antenna type and its
gain should be so chosen that the equivalent iso-
tropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
Canada, le présent émetteur radio peut fonctionner
avec une antenne d'un type et d'un gain maximal (ou
inférieur) approuvé pour l'émetteur par Industrie
Canada. Dans le but de réduire les risques de brouil-
lage radioélectrique à l'intention des autres util-
isateurs, il faut choisir le type d'antenne et son gain
de sorte que la puissance isotrope rayonnée équi-
valente (p.i.r.e.) ne dépasse pas l'intensité néces-
saire à l'établissement d'une communication
satisfaisante.
This device complies with Innovation, Science and
Economic Development Canada license-exempt
RSS standard(s). Operation is subject to the fol-
lowing two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radio électrique subi,
même si le brouillage est susceptible d'en com-
promettre le fonctionnement.
RF Exposure (FCC/ISED)
Compliance Statement Canada Déclaration de Conformité
This equipment complies with radiation exposure
limits set forth for an uncontrolled environment.
The IMRB-EXT vehicle antenna(s) must be
installed to provide a separation distance of at
least 20 cm from all persons and must not be co-
located or operating in conjunction with any other
antenna or transmitter.
Cet équipement est conforme à l'exposition au ray-
onnement limites définies pour un environnement
non contrôlé. L'antenne du véhicule IMRB-EXT doit
être installée de manière à prévoir une distance de
séparation d'au moins 20 cm de toutes les per-
sonnes et ne doit pas être colocalisé ou fonc-
tionnant en conjonction avec toute autre antenne
ou émetteur.
Electromagnetic compatibility
Caution: ELECTROMAGNETIC COMPATIBILITY
Use only approved accessories with this equipment. In general all cables must be high qual-
ity, shielded, and correctly terminated. Unapproved modifications or operation beyond or in
conflict with these instructions for use, may void authorization by the authorities to operate
the equipment.
Important: Changes or modifications to the device or its antenna not expressly approved by the
party responsible for compliance could void the user’s authority to operate the device.
Transportation classification
14 May 2019
TDC-1719-002
6
Itron Mobile Radio User Guide