User's Guide
Table Of Contents
- Table of Contents
- Itron Mobile Radio compliance
- 1. Introduction
- 2. About Your Itron Mobile Radio
- 3. Daily Operation
- 4. LED Status Indicators
- 5. Communication Ports
- 6. Carrying the Portable Itron Mobile Radio
- 7. Installing the IMR-XA and IMR-FT
- 8. Maintaining your Itron Mobile Radio
- 9. Storing Your Radio
- 10. Battery Basics
- 11. Safety
- 12. Troubleshooting
- 13. Optimizing Bluetooth® Performance
- 14. Itron Mobile Radio Capabilities and Limitations
several hours while the battery charges and you should eventually see
the power LED turn solid red, indicating it is charging, and finally solid
green, indicating that it is fully charged and ready for use. If the white
LED never turns off while the IMR is connected to power, the battery is
likely bad and must be replaced. This will need to be done approximately
every 300 to 500 charge cycles. See Installing a Replacement Bat-
tery on page20.
Comm Indicator LED Table
The following table describes the LED colors and patterns for the most common radio con-
ditions.
Comm indicator
Solid Flash
green
USB connected
white
Error
blue
Bluetooth® connected
blue
Bluetooth low energy connected
Note The application connected to the radio may assign a display pattern to the LEDs that is not
described in these tables.
14 May 2019 TDC-1719-002 8
Itron Mobile Radio User Guide 4. LED Status Indicators